Irish Cement was required to remove a section of the kiln to facilitate removal and replacement of one of the “tyres”. This involved cutting out the section very accurately, as it had to be replaced after the new tyre had been fitted, and making the bevel cuts on both the remaining sections of the kiln and also the section that had been removed.

In this case, Gullco were asked to supply the equipment and the services of an engineer to oversee the installation, set up and actual cutting of the kiln. Irish Cement were using contractors for this project and they were responsible for making the cuts.

Again, the equipment went together very well and was installed easily and accurately. The cuts were completed with no problems and well within the allotted time.